So I changed the date to the correct date. Windows update also errored because of the wrong date. Try to use flexnet connect to update but it failed.
![chrysler drb iii turn on chrysler drb iii turn on](https://txsglobalstore.com/wp-content/uploads/2019/08/s-l1600-1-1-600x600.jpg)
#CHRYSLER DRB III TURN ON INSTALL#
In the beginning when installing the stubs, his directions had already instructed you to change the date to 1/1/17, then navigate to the folder and install the three stubs.
![chrysler drb iii turn on chrysler drb iii turn on](http://blog.obdexpress.co.uk/wp-content/uploads/2019/03/drb3-emulator-vci-pod-clone-3-600x489.jpg)
In order to get it to work, I had to change the date. I had to change it up since I did follow his instructions exactly, but the flexnet update didn’t work, and so it failed and te drb3 did not work. Anyway I will have to contact the seller and arrange for some discount since the hard drive is virtually useless.Īnyway, the main thing is that the miocropod had the required circuits etc, and the DRB3 works after following most of Radius’s instructions. I was able to make a backup though and there is actually a second partition on it with an Acronis backup image already created from 8/15/17. Its making beeping sounds and clicking and on its very last legs. It came with a hard drive that is barely working. I bought my micropod from the same seller Radius bought his from.
![chrysler drb iii turn on chrysler drb iii turn on](https://i.ebayimg.com/images/g/9tYAAOSwHUFg3O0h/s-l640.jpg)
When green LED turns on, turn on car ignitionĢ4: When Windows is done installing drivers, etc, you should show a network connection in the tool tray with no internet accessĢ6: Press “Launch DRB III” button in lower right hand cornerīy following the above instruction, one user share his good experience: Do NOT update WiTech!!!ġ6: Flexnet will find updates for enhanced DRB and K-LineĢ0: Once updates and downloaded and installed, turn OFF internet and NEVER turn on again!Ģ2: Attach Micropod to car. Option 1: Bought MicroPod 2 from one Chinese Seller:ġ: Make a backup copy of the partition from the hard drive included with the micropod!ģ: Set date to 01/01/17 BEFORE booting from laptopĥ: Allow windows to install drivers, etc, as needed for your laptop and reboot as needed.Ħ: Once all of that is done, do NOT run WiTech yet!Ĩ: Navigate to C:\ProgramData\wiTECH\jserver\data\core\stubsġ5: Run Flexnet software updater. These are the steps I followed to use MicroPod 2 Clone to get Enhanced DRB III Emulator to work: